Table of Contents

Quick Start Guide

Niamh Ferns Updated by Niamh Ferns

Deployment Quick Start Guide

Estimated Time: 2 hours

In the videos below, we run you through everything needed to get PowerPlay up and running, and show you how to deploy Entra Sync Groups as your first solution.

Checklist

We've prepared a checklist for you to follow along. It contains all the steps you'll need to take in order to get everything up and running smoothly. We recommend you copy the checklist to somewhere local so you can cross off as you go and take notes as needed: CHECKLIST

Environment Provisioning and Setup Video Guides

Initial Setup & Preparation
Environment Provisioning
Post-deployment Steps - Connections
Post-deployment Steps - Environment Variables
Post-deployment Steps - Enabling Flows

You can find more information on the steps mentioned above in the articles below. These cover the ServOrg and CustOrg deployment steps in detail.

  1. Perform the pre-deployment checks
  2. Provision and Deploy your Service Provider and Customer Environments
  3. Complete the Post-deployment Steps
  4. Configure your Service Orchestrator

Sync Entra Groups - Video Guides

ALM Deployment
Connection References & Environment Variables
Cloud Flows
Sync Entra Groups Table
Configuring User Groups

You can find more information on the steps mentioned above in the articles below. This article covers the Sync Entra Groups solution deployment steps in detail.

Deploy the Sync Entra Groups solution.

For the smoothest possible experience and to get everything up and running with minimal effort on your end, we recommend continuing with an ALM deployment for the Sync Entra Groups solution.

The guide linked above will show you how to do both the ALM and self-service deployments, so you can choose one that works for you.

Troubleshooting

When following the above steps, you may run into some roadblocks. For troubleshooting steps related to each section, please review either the Deployment or Post-Deployment documents. If you run into issues with your scripts, we recommend that you re-review the pre-deployment checks and make sure all of these are completed fully.

Most often, people will run into steps during post deployment. In general, we recommend that you:

  • Confirm that you have followed the steps in order
  • Make sure you are not skipping sections. Rewatch the videos to ensure that all the sections have been completed fully.
  • Review your environment variables to ensure they are all correctly set and have been saved.
  • Make sure you are enabling flows in the correct order, as some flows require others to be turned on before they can be.

For the Sync Entra Groups solution, there is a set of troubleshooting steps as well.

How did we do?

Overview & Introduction

Quick Start Checklist

Contact